i need opinion's

so everyone has seen my nav bezel and ashtray airbrushed with black flames and skull by now,my question is should i do the steering wheel control,speedometer rings, and console pc the same way or just kee;p the nav bezel done only????

and how hard is it to get those pc's out?

here's a pic again of center pc

yea I would just to match it up!

Match them and those pieces are easy to get out. However I may suggest you let someone else do it since you seem to be prone to breaking things when removing them.

Okie5.7 wrote:

Match them and those pieces are easy to get out. However I may suggest you let someone else do it since you seem to be prone to breaking things when removing them.

lmfao!!!! I agree I would match everything up.

i gotta try it myself. i heard the cluster rings are held in by snaps.and shift plate is held in by a few screws and that snap's out .the steering wheel the front bottom snap out ,disconnect battery ,two screws unbolt and lower down and remove top two....they say to use screwdrivers to pry im either going to use credit card or a non-sharp plactic......does this processing sound about right? ..

for the controls ,get a flat head and wrap tape around the tip . but go slowly cuz if you try to go to fast ,you might break/crack them.

Don't think your processing right but have the process down almost. It's only two screws for the shifter surround area. Remove plastic piece below the ashtray and you'll see the screws. None of it is two hard to remove. If you break something what do I get? Hahaha

i forgot to add that i had ashtray is already out

i might wait a few days till its warmer......

fuck it it's warm enough

i have the same computer desk....

Whats the card for??????

the card was my interior removal tool aka jewel preferred card.everything went smooth, on one of the controls i found some stress cracking around the edge but we will try to cover with the paint.i dont want to spend 60 bucks on a new one .one question i do have is i i noticed before that the gauge plastic trim(not the rings) was sticking out it the middle.so i unsnapped the upper part and found three tabs .one on each end and one in the middle .they are junk almost like flexible plastic.i had the same problem with the center bezel i used gel superglue to re-enforce it and it worked well.i also thought about spreading the metal tabs more any suggestions?